Illustration af DIY-vandingssæt med kapacitiv jordfugtighedssensor, relæ, pumpe, batteriholder, jumperkabler og 50 cm slange
Automatic watering DIY kit with capacitive soil moisture sensor and pump
Automatic watering DIY kit with capacitive soil moisture sensor and pump
Automatic watering DIY kit with capacitive soil moisture sensor and pump
Automatic watering DIY kit with capacitive soil moisture sensor and pump
Automatic watering DIY kit with capacitive soil moisture sensor and pump
  • Illustration af DIY-vandingssæt med kapacitiv jordfugtighedssensor, relæ, pumpe, batteriholder, jumperkabler og 50 cm slange
  • Automatic watering DIY kit with capacitive soil moisture sensor and pump
  • Automatic watering DIY kit with capacitive soil moisture sensor and pump
  • Automatic watering DIY kit with capacitive soil moisture sensor and pump
  • Automatic watering DIY kit with capacitive soil moisture sensor and pump
  • Automatic watering DIY kit with capacitive soil moisture sensor and pump

Automatic watering DIY kit with capacitive soil moisture sensor and pump

99,00 kr
9 in stock
Quantity

Dispatched from Aarhus, Denmark. Shipping calculated at checkout.

Need help choosing? Ask us about your project

Illustration af DIY-vandingssæt med kapacitiv jordfugtighedssensor, relæ, pumpe, batteriholder, jumperkabler og 50 cm slange

Automatic watering DIY kit with capacitive soil moisture sensor and pump

99,00 kr

Before you buy: This is a component kit, not a ready-to-run automatic watering system. A controller such as Arduino or ESP32 and a USB-C cable are not included. Automatic control requires a suitable controller, programming and correctly matched power supplies. Confirm the pump variant, battery holder and relay input requirements before choosing additional parts.

Automatic watering DIY kit

Build an automatic plant-watering system with a capacitive soil moisture sensor, relay and water pump. The sensor measures soil moisture and sends an analogue signal to a controller such as an Arduino or ESP32. Your code can switch the relay when moisture falls below the chosen threshold, starting the pump.

Capacitive measurement avoids the exposed measuring electrodes used by resistive probes and reduces electrode corrosion. This kit contains a capacitive sensor, not the former LM393 resistive sensor listing.

Check the supply requirements of each part before connecting it. Never power the pump directly from a GPIO. Verify the relay input circuit before connecting a controller; a 5 V supply rating does not confirm compatibility with 3.3 V GPIO. Analogue signals require an ADC, which a standard Raspberry Pi computer does not have built in.

SensorCapacitive soil moisture sensor
Sensor supply3.3–5.5 V DC
Sensor outputAnalogue, approximately 0–3.0 V
Sensor interfacePH2.54-3P: VCC, GND, analogue signal
Relay1-channel 5 V relay module
PumpMini submersible water pump
Pump rated voltage3 V / 4.5 V DC
Pump rated currentApproximately 0.18 A
Maximum flowUp to approximately 100 L/h without load
Hose lengthApproximately 50 cm
  • 1 × capacitive soil moisture sensor
  • 1 × 1-channel 5 V relay module
  • 1 × mini water pump
  • 1 × battery holder
  • Jumper wires
  • Approximately 50 cm water hose

Arduino, ESP32 or another controller and a USB-C cable are not included.

Warranty and shipping

Contact us if there is a problem with your item. We dispatch from Aarhus to Denmark and Sweden. Shipping options and prices are shown at checkout. Delivery time depends on availability, destination and shipping method; contact us before ordering if you have a specific deadline.